• Custom extruded aluminum enclosure with PPG Duranar finish

• Designed to mate to and match new curtain wall, coordinated with curtain wall trade partner

• High performance fan with 24V EC motor and factory configured CFM set point (limited field air balancing required)

• Pressure independent control valve with factory configured GPM set-point (limited field water balancing required)

• Pre-configured direct digital controls

• Single point connection for power, control, and communication

• Quick connect low voltage wiring

• Fully insulated piping package

• Unit specific laser engraved tagging

• Tested for performance, sound, and leakage of entire assembly

• Designed for easy access for units, controls, and piping

• Throwaway filter

• Units individually boxed, packaging materials used for field protection

• Units delivered on pallets as coordinated with installing contractor to fit in hoist

• Staging and storage will be coordinated with installing contractor

• Submittals to include unique unit layout drawings for each floor with: – Tagging

• Risers locations

• Electrical connections

• 3rd party certified unit performance test on each unit type (by Intertek)

• 3rd party certified unit sound test on each unit type (by Intertek)

• Testing report submitted for record and available online via laser etched QR code

• Factory pressure test for each unit utilizing NIST traceable instrumentation

• Pressure recorded electronically at 1 second intervals

• TecspecSystem Optimized ValveTM for variable air and water controls

• Factory installed return air sensor

• no wall thermostat and associated field wiring required)

• Factory installed condensate/leak sensor and associated controls for valve shutoff

• Factory installed entering water temperature sensor

• No field wiring required except for quick connect inter unit power and communication

• Stand alone controls

• Each unit has over 100 BACnet points available for future BMS integration

Electrical Requirements

• Provide 120V, 20 Amp. Circuit per Submittal Drawing

• Each 20 Amp Circuit with serve (24) Units utilizing (3) Drops 

Mechanical Requirements

• Receive and Install Unit

• Connect low voltage interconnecting cable between Sections

• Final Piping Connections 

Future BMS Integration Requirements

• (2) BACnet IP Drops per floor for future BMS Integration (typical)

• Each Unit will be factory configured with a unique device instance (BACnet Address) to allow seamless BMS Integration (No Dip Switch Settings or Field Addressing Required)

• Each unit will be factory configured with system alarm points for future BMS Integration (No Field Alarm Programming Required)

• Each Unit will be factory configured with Energy Management routines for future BMS Integration (No field Programming required)